Construction codes of Ontario

→ View our videos on Tiktok ↓ Code related products on Amazon

PIKETS Bidet Attachment for Toilet, Dual Nozzle (Frontal and Rear Wash) Non-Electric Fresh Water Toilet Seat Attachment with ...

$39.99

General Receptables (see Appendices B and G)

General Receptables (see Appendices B and G) Receptacles for all residential occupancies (including dwelling units and single dwellings) shall meet thefollowing requirements: a) for the purposes of this Rule, i) “finished wall” shall mean any wall finished to within 450 mm of the floor with drywall, wood panelling, or like material; andii) a controlled outlet […]

Grade Marking (Lumber and Wood Products)

Grade Marking (1) Lumber for joists, rafters, trusses and beams and for the uses listed in Table 9.3.2.1. shall be identified by a grade stamp to indicate its grade as determined by the NLGA, “Standard Grading Rules for Canadian Lumber”. Article 9.3.2.1 Ontario Regulation 332/12 Building Code, Information published by oncodes.ca for educational purposes only.

Grout Mix Proportions (by Volume)

Grout Mix Proportions (by Volume) Table 9.20.3.2.C.Grout Mix Proportions (by Volume) Forming Part of Sentence 9.20.3.2.(4) Table 9.20.3.2C. Ontario Regulation 332/12 Building Code, Information published by oncodes.ca for educational purposes only.

Guards

(1) Except as provided in Sentence (6) and Articles 3.3.2.8. and 3.3.4.7., a guard not less than 1 070 mm high shall be provided, (a) around each roof to which access is provided for other than maintenance, (b) at openings into smoke shafts referred to in Subsection 3.2.6. that are less than 1 070 […]

Guards Designed Not to Facilitate Climbing

Guards Designed Not to Facilitate Climbing (1) Guards required by Article 9.8.8.1., except those in industrial occupancies and where it can be shown that the location and size of openings do not represent a hazard, shall be designed so that no member, attachment or opening located between 140 mm and 900 mm above the floor or […]

Gypsum Board Materials

Gypsum Board Materials (1) Gypsum products shall conform to, (a) CAN/CSA-A82.27-M, “Gypsum Board”, (b) ASTM C1178 / C1178M, “Coated Glass Mat Water-Resistant Gypsum Backing Panel”, or (c) ASTM C1396 / C1396M, “Gypsum Board”. Article 9.29.5.2 Ontario Regulation 332/12 Building Code, Information published by oncodes.ca for educational purposes only

Gypsum Board Maximum Spacing of Supports

Gypsum Board Maximum Spacing of Supports (1) Maximum spacing of supports for gypsum board applied as a single layer shall conform to Table 9.29.5.3. Article 9.29.5.3. Ontario Regulation 332/12 Building Code, Information published by oncodes.ca for educational purposes only. GYPSUM BOARD FINISH Gypsum board is the most widely used interior finish because of its speed […]